Description
Coolaroo Idle End Unit
The Coolaroo Idle End Unit End Bracket is suitable for use with both corded and cordless on Coolaroo Exterior Sun Shades. The idle end brackets are used to secure the idle end of the shade to the mounting surface. The idle end is necessary for functionality.
This component can be adjusted for both right and left side use as needed.
Right and left refer to the current orientation of the control unit.
The idle end will always be on the opposite side of the control unit.
Switching Chain Position
Changing to a Left-Hand Chain Control
If you want your chain to be on the left side of your blind, you
will need to make a simple change to your Clutch Unit before you
install your blind. To make this change, start by sliding off the
Bracket Cover on the Clutch Unit
(Fig. 10). Remove the four screws.
Turn the unit 180 degrees so the chain can now hang down from
the left side (Fig. 11). Put the screws back in, and slide the Bracket
Cover back on. No change is needed to the Idle End Unit, it works
for right and left mounts. Pull out both End Plugs from the tube
and switch them (Fig. 11).
Changing to a Top/Ceiling Mount
If you want your Clutch Unit to hang from the top (for example,
the ceiling), you will need to make a simple change to your Clutch
Unit and Idle End Unit before you install your blind. To make this
change, start by sliding off the Bracket Covers on both the Clutch
Unit and Idle End Unit (Fig. 13). Remove the four screws from
both brackets. Turn the Clutch Unit 90 degrees so the chain hangs
straight down if the Clutch
were hanging from the top,
and turn the Idle End Unit
so the opening is facing
away from the window.
(Fig. 14). Put screws back
in, and slide the Bracket
Cover back on.
